A NEW KERNERATOR MODEL
(Slip-In Type) For New and Existing Buildings
Kernerator Research Laboratory and Engineering Department have collaborated in producing
MODEL A-l
for moderately priced homes, and dwellings where space is limited
A COMPLETE UNIT
As shipped Model A-l is a complete unit with DUAL GAS DRYER-IGNITOR, a pilot for lighting either Dryer or Ignitor without opening fire or ash doors; a completely enclosed top adjustable for the usual flue positions, made up for either 12 x Y2 or 8^ x 8 flue tile. It requires no assembly after leaving the factory except for gas connection by the gas fitter.
When the brick niche is completed to the required height, the Unit slips into place, proper sized flue tile is set, and flue construction started. Steel members are provided for carrying weight of the flue on the brick sidewalls.
LOW INSTALLATION COST
Material and labor installation costs are cut to a minimum. The A-l Kernerator comes to the job completely assembled and requires no brick chamber construction. The unit can be bricked into place; no dimensions have to be followed. NO FIRE BRICK IS REQUIRED. The Unit occupies a space less than 19 square, only slightly more than that required for supporting the breast of a 12 x 12 flue.
DUAL GAS DRYER-IGNITOR
Kernerator Model A-l is the only incinerator with this dual type of dryer and primary ignitor.
Experience has shown that with small capacity incinerators a fairly large flame is required to start the material burning; also that if the material is unusually wet, far greater efficiency is obtained by drying out before burning. Both results are accomplished by the Dual DryerIgnitor. Kernerator engineers have combined both types of flame in one unit, increasing the efficiency and satisfactory operation of the incinerator.
Specification Sheet giving full details (A. I. A. File) mailed on request.
KERNER INCINERATOR COMPANY
3548 N. Richards St.
Milwaukee, Wis.
Offices in over 150 cities
(Slip-In Type) For New and Existing Buildings
Kernerator Research Laboratory and Engineering Department have collaborated in producing
MODEL A-l
for moderately priced homes, and dwellings where space is limited
A COMPLETE UNIT
As shipped Model A-l is a complete unit with DUAL GAS DRYER-IGNITOR, a pilot for lighting either Dryer or Ignitor without opening fire or ash doors; a completely enclosed top adjustable for the usual flue positions, made up for either 12 x Y2 or 8^ x 8 flue tile. It requires no assembly after leaving the factory except for gas connection by the gas fitter.
When the brick niche is completed to the required height, the Unit slips into place, proper sized flue tile is set, and flue construction started. Steel members are provided for carrying weight of the flue on the brick sidewalls.
LOW INSTALLATION COST
Material and labor installation costs are cut to a minimum. The A-l Kernerator comes to the job completely assembled and requires no brick chamber construction. The unit can be bricked into place; no dimensions have to be followed. NO FIRE BRICK IS REQUIRED. The Unit occupies a space less than 19 square, only slightly more than that required for supporting the breast of a 12 x 12 flue.
DUAL GAS DRYER-IGNITOR
Kernerator Model A-l is the only incinerator with this dual type of dryer and primary ignitor.
Experience has shown that with small capacity incinerators a fairly large flame is required to start the material burning; also that if the material is unusually wet, far greater efficiency is obtained by drying out before burning. Both results are accomplished by the Dual DryerIgnitor. Kernerator engineers have combined both types of flame in one unit, increasing the efficiency and satisfactory operation of the incinerator.
Specification Sheet giving full details (A. I. A. File) mailed on request.
KERNER INCINERATOR COMPANY
3548 N. Richards St.
Milwaukee, Wis.
Offices in over 150 cities